Все науки. №6, 2022. Международный научный журнал

Speaking about the described scientific work, it is important to note that it was primarily a theoretical work in which calculations of extremely high values took place in connection with the current, when the charges of the beams are extremely large, as are the currents, reaching several kA. And only at the end more approximate data were taken into account. In this case, the calculation is also carried out at the moment when the currents are small and more close to the real ones. For comparison, the currents in the newly created DC-280 cyclotron did not reach a value of 1 A, but were measured only in mA.

The same parameters can be given for the EG-2 SOKOL electrostatic accelerator, now owned by the Research Institute of Semiconductors and Microelectronics at the National University of the Republic of Uzbekistan.

Therefore, in order to carry out this kind of nuclear reactions, when special conditions are necessary, they must once again be specified and clarified, as close as possible to the real values. In addition, if we dwell in detail on the mechanism of reactions, we get a picture from the fact that, as indicated, it is important to have a special device – an accelerator of charged particles, which could impart more energy in the amount of several MeV, for a charged particle. After that, this particle would come across a target of a certain substance, thanks to which a certain nuclear reaction took place. At the same time, a number of processes occur, one of which is overcoming the Coulomb barrier, that is, even if a nuclear reaction occurs with an energy output, the particle must still expend some energy to carry out this action, but if you choose a general combination as follows, so that such an amount of energy is expended, so that eventually a small amount remains by turning the incoming particle into a slow one, the probability of this reaction passing sharply increases to not small values, already after the Coulomb barrier, when Coulomb forces are no longer taken into account and the process takes place at a nuclear radius, as indicated.

Thus, it is important to create an LCU that would give energy to charged particles with a 9—10 order, which significantly increases the efficiency of the entire system under study and leads to a more accurate determination of the Coulomb and other barriers of any reaction. At the same time, this LCC has a number of advantages along with all available accelerators, since, to begin with, it is a combination of two classes of accelerators: cyclic and linear.

Speaking of accelerators, it is important to note that accelerators themselves are simple, in which particles are accelerated by an electric field, the whole principle is based on this. It is also impossible to doubt that the time has finally come for the reaction of the first resonant nuclear reactions at the first LCC. After all, if we resort to history, then, for example, the very first accelerator was built in 1930 by Lawrence Berkeley. The first accelerators are considered to be the accelerators of 1931, when a 23 cm ring cyclotron was created at the University of California to accelerate hydrogen ions with an energy of 1 MeV. A 28 cm ring proton cyclotron with an energy of 1.2 MeV was also developed in Berkeley in 1932. There, at the University of California, Berkeley, a 68 cm ring deuterium cyclotron with an energy of 4.8 MeV was developed from 1932 to 1936; a 94 cm ring deuterium cyclotron with an energy of 8 MeV was developed from 1937 to 1938; a 152 cm ring tritium cyclotron with an energy of 16 MeV was developed from 1939 to the present time; from 1942 to the present The operating time is 467 cm ring cyclotron for various charged particles with an energy of more than 100 MeV. At the same time, in 1932, a proton electrostatic proton accelerator with an energy of 0.7 MeV Cockcroft-Walton was constructed at the Cavendish Laboratory, acting thanks to the voltage multiplier of Ernest Thomas Sinton Walton and Sir John Douglas Cockcroft (winners of 1951), already better known as the Cockcroft-Walton voltage multiplier.

Also known are Harvard accelerators (1949—2002), Oak Ridge National Laboratory (1943-present) for protons and uranium nuclei with energies from 160 MeV. Synchrotrons were also created, known as the cosmotron at Brookhaven National Laboratory, 1953—1968. 72 meters for protons at 3.3 GeV, also the Birmingham sychrotron, Bevatro, the Saturn accelerator, the Russian synchrophasotron in Dubna, the Proton cyclotron at CERN. Listing accelerators can be quite a long process, not to mention describing each one, due to the difference in their types, characteristics and physics. Therefore, there is no room for doubts about the passage of a sufficient path in this area on the part of world science to begin research and work in the design of the newest resonant-type cyclotron.

The purpose of this research work is the complete development of the charged particle accelerator «LCU-EPD-20» (linear cyclotron accelerator proton-deuterium cyclotron for the Electron project with an energy of up to 20 MeV, with a high order), for a detailed study of resonant nuclear reactions.

The objectives of this study are:

• Study of the general system of operation, physics and history of accelerators;

• Development of an electric acceleration system (RF system);

• Calculation of parameters and algorithm for creating a magnetic system;

• Study of the vacuum system and development of a method to achieve the required vacuum level;

• Development of a system for monitoring the action of the accelerator and giving the necessary level of energy;

• Development of the mechanism and physics of detecting the results obtained;

• Creation of technology for mathematical modeling of the charged particle accelerator system;

• Description of variations of accelerator operation using examples of resonant nuclear reactions.

The object of this study is a resonance type charged particle accelerator LCU-EPD-20.

The subject of the study is the study of the process of creating a resonance-type charged particle accelerator, and the technology of conducting experiments on this accelerator.

For this study, an instrumental, empirical and theoretical research method was applied (with some reservations), which gave the necessary important results.

The scientific novelty of this research work is as follows:

• The first merger of two classes of accelerators: cyclotron and linear, resulting in the formation of the LCU system;

• For the first time, a system operating on a scale of 9—10 orders of magnitude is being developed;

• It is possible to conduct experiments with energy values of 3 units of 11—12 orders of magnitude, due to the variation of the value up to 20 MeV;

• The first application of the possibility of conducting nuclear reactions on protons and deuterons with Coulomb barriers on any nuclei;

• The only device on the planet in the entire history of mankind with such critical experimental accuracy;

• Indicated as the first research in the field of physics of resonant nuclear reactions;

• The first presentation of a charged particle accelerator as a source of electrical energy;

• The only studies as an accelerator without switching to the method of generating electric energy with the transition to a pit mechanism;

• Huge amount of generated electrical energy;

• The possibility of switching to higher cores (from 119 cores).

Speaking about the novelty of this study, along with a lot of points, which in this case are only partially given, it is important to clarify the fact that the feature of the accelerator being created for the research laboratory under the Electron project LCU-EPD-20 is accuracy. It is the ability to give duants a certain voltage, that when passing through the slits of the electric field, where the beam is accelerated, it is accelerated only by a certain number, which is only a part of the final energy.

As can be indicated in the very name of the reaction, it is necessary to cause resonance, but not because of a particular «coincidence», namely because of the energy approach, as described earlier, but will be described in even more detail in subsequent chapters, where the history of accelerator technology is initially given, then the basic physical and mathematical apparatus is developed, allowing to already operate with the resulting beam acceleration systems.

The practical results will be as follows:

• A whole program has been developed for the implementation of LCU-EPD-20;

• All the necessary data of LCU-EPD-20 have been calculated;

• All physics and working methods for the new LCU-EPD-20 have been obtained;

• The technology of creating the LCC-EPD-20 accelerator has been developed;

• Distinctive features of resonant accelerators are expressed;

• The project of the research laboratory under the new project «Electron» with the use of LCU-EPD-20 has been developed;

• The concept of a research laboratory under the Electron project using LCU-EPD-20 has been developed;

• The monograph «The use of accelerators and the phenomena of collisions of elementary particles with high-order energy for the generation of electrical energy. The Electron Project» with a description of the 1st stage of the Electron project research;

• It is planned to publish a whole list of monographs for a detailed description of the LCC-EPD-20 accelerator project;

• The «Road map» of the Electron project has been developed.

The reliability of the results is based on the fact that generally accepted mathematical, physical and other operations will be used. Experimental data obtained in various laboratories and research centers, as well as from the practice of scientists, on the creation of such accelerators will also be used.

This research was discussed more than once at a meeting of doctors and candidates of physical and mathematical Sciences of Fergana State University, reviewers of the monograph on the 1st stage of the Electron project, scientists of the Fergana Polytechnic Institute, as well as during a discussion with a doctor of Technical Sciences, associate professor of the Research Institute of Semiconductor Physics and Microelectronics of the National University of Uzbekistan.

The results of the research are published in scientific articles in the international journals «Exact Science», «Young Scientist» and some others, in this monograph and in the monograph of Aliyev I. H. and Sharofutdinova F. M. «The use of accelerators and phenomena of collisions of elementary particles with high-order energy for generating electrical energy. The Electron Project», published back in 2021, the reviewers for which were Doctor of Physical and Mathematical Sciences, Professor of the Faculty of Physics and Technology of Fergana State University Otazhonov Salim Madrahimovich, Doctor of Technical Sciences, Associate Professor of the Research Institute of Semiconductor Physics and Microelectronics of the National University of Uzbekistan Kuldashev Obbos Khakimovich, Candidate of Physical and Mathematical Sciences, Associate Professor of the Faculty of Physics and Technology of Fergana State University Karimov Bokhodir Khoshimovich, Candidate of Physical and Mathematical Sciences, Associate Professor of Physics-Abdurakhmonov Sultonali Madrahimovich, PhD in Physics and Mathematics, Senior Lecturer of the Faculty of Physics and Technology of Fergana State University Zainolobidinova Sapura Malikovna, Senior Lecturer of the Faculty of Physics and Technology of Fergana State University Yuldoshaliev Dilshod Kuldoshalievich».

This is exactly what the project of the world’s first resonant type accelerator LCC-EPD-20 looks like at the moment. And after carrying out the entire Electron project, it is possible to achieve the implementation of a grandiose work that opens up new opportunities, makes the whole state completely energy independent, because these 17.56 GWh of electric energy is more than enough to provide the entire Republic of Uzbekistan by 174.4%, thanks to which a new branch of infrastructure may appear, which is the direction of energy exports from the state, which will also lead to the improvement and development of the state economy, not only in the industrial sense, but also in the real scientific sense!